I'd like to talk about edge finders

[krv3000]

hi this is a old way of seting up on senter get a dawel say 6mm od put it in the mill and cote the dawel in marker pen bring the dawel to the work pece and tuch on the work pece once you see the ink bin rubed off stop the mill then if you have a dro set to 0 then remove 3mm and reset the dro to 0 the other metherd is to use cigeret papers dampen the edge of the work pece and place a pece of cigeret paper on it bring say a 10mm slot drill to the work pece wher the paper is and cerfuly bring the cuter to the work pece as soon as the cuter pics up the paper stop the paper is so meney microns thik deduced that with hafe the thiknes of the cuter then you is on center