How can I do it without the fixture shown in this video

Thread Modes

How can I do it without the fixture shown in this video - Driving Pulley

Hawkeye Offline

Junior

Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada

10-28-2013, 08:46 PM

The key is that you know what you need to do. Somehow hold your blank on the toolpost so that it can rotate freely against the tap in the spindle. Any way you can think of to do that will be the right way. It doesn't have to look like the one in the video.

Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

How can I do it without the fixture shown in this video - Driving Pulley - by Wongster - 10-28-2013, 12:33 PM

RE: How can I do it without the fixture shown in this video - Driving Pulley - by EdK - 10-28-2013, 01:24 PM

RE: How can I do it without the fixture shown in this video - Driving Pulley - by dallen - 10-28-2013, 02:22 PM

RE: How can I do it without the fixture shown in this video - Driving Pulley - by DaveH - 10-28-2013, 02:25 PM

RE: How can I do it without the fixture shown in this video - Driving Pulley - by Wongster - 10-28-2013, 06:23 PM

RE: How can I do it without the fixture shown in this video - Driving Pulley - by Hawkeye - 10-28-2013, 08:46 PM

RE: How can I do it without the fixture shown in this video - Driving Pulley - by DaveH - 10-29-2013, 06:03 AM

RE: How can I do it without the fixture shown in this video - Driving Pulley - by TomG - 10-29-2013, 07:48 AM