MetalworkingFun Forum › Machining › General Metalworking Discussion v
VFD for return to 3ph?

Thread Modes
VFD for return to 3ph?
awemawson Offline
Junior
****
Posts: 642
Threads: 14
Joined: Oct 2013
Location: East Sussex, UK
#9
10-22-2013, 09:32 AM
I assume that's a single phase motor driving a three phase motor as a generator. Do you have to excite one of the three phase windings or does it self start from residual magnetism?
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:


Messages In This Thread
VFD for return to 3ph? - by stevec - 10-21-2013, 12:27 PM
RE: VFD for return to 3ph? - by 12345678910 - 10-21-2013, 01:11 PM
RE: VFD for return to 3ph? - by stevec - 10-21-2013, 02:41 PM
RE: VFD for return to 3ph? - by EdK - 10-21-2013, 04:51 PM
RE: VFD for return to 3ph? - by 12345678910 - 10-21-2013, 04:55 PM
RE: VFD for return to 3ph? - by stevec - 10-21-2013, 06:14 PM
RE: VFD for return to 3ph? - by 12345678910 - 10-21-2013, 08:13 PM
RE: VFD for return to 3ph? - by Sunset Machine - 10-22-2013, 07:00 AM
RE: VFD for return to 3ph? - by awemawson - 10-22-2013, 09:32 AM
RE: VFD for return to 3ph? - by Sunset Machine - 10-22-2013, 07:54 PM
RE: VFD for return to 3ph? - by PixMan - 10-23-2013, 06:54 AM
RE: VFD for return to 3ph? - by stevec - 10-23-2013, 06:57 AM
RE: VFD for return to 3ph? - by f350ca - 10-23-2013, 09:44 AM
RE: VFD for return to 3ph? - by Sunset Machine - 10-23-2013, 08:40 AM
RE: VFD for return to 3ph? - by Mayhem - 10-23-2013, 08:44 AM
RE: VFD for return to 3ph? - by LJP - 10-23-2013, 09:42 AM
RE: VFD for return to 3ph? - by stevec - 10-23-2013, 04:23 PM



Users browsing this thread: 7 Guest(s)