VFD for return to 3ph?

Hello There, Guest! Register

Thread Modes

VFD for return to 3ph?

stevec Offline

Offline

69 yr. old senior

Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada

#6

10-21-2013, 06:14 PM

123-, gotcha, sounds good. Now, if you change from say , your 5hp lathe to your 3hp mill do you have to change settings in the VFD?

Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

VFD for return to 3ph? - by stevec - 10-21-2013, 12:27 PM

RE: VFD for return to 3ph? - by 12345678910 - 10-21-2013, 01:11 PM

RE: VFD for return to 3ph? - by stevec - 10-21-2013, 02:41 PM

RE: VFD for return to 3ph? - by EdK - 10-21-2013, 04:51 PM

RE: VFD for return to 3ph? - by 12345678910 - 10-21-2013, 04:55 PM

RE: VFD for return to 3ph? - by stevec - 10-21-2013, 06:14 PM

RE: VFD for return to 3ph? - by 12345678910 - 10-21-2013, 08:13 PM

RE: VFD for return to 3ph? - by Sunset Machine - 10-22-2013, 07:00 AM

RE: VFD for return to 3ph? - by awemawson - 10-22-2013, 09:32 AM

RE: VFD for return to 3ph? - by Sunset Machine - 10-22-2013, 07:54 PM

RE: VFD for return to 3ph? - by PixMan - 10-23-2013, 06:54 AM

RE: VFD for return to 3ph? - by stevec - 10-23-2013, 06:57 AM

RE: VFD for return to 3ph? - by f350ca - 10-23-2013, 09:44 AM

RE: VFD for return to 3ph? - by Sunset Machine - 10-23-2013, 08:40 AM

RE: VFD for return to 3ph? - by Mayhem - 10-23-2013, 08:44 AM

RE: VFD for return to 3ph? - by LJP - 10-23-2013, 09:42 AM

RE: VFD for return to 3ph? - by stevec - 10-23-2013, 04:23 PM

Users browsing this thread: 7 Guest(s)