|
Knurling Vial Caps
|
10-17-2013, 06:11 PM
The swiveling angle of the knurl (wheel) holders doesn't need to be geared, IMHO that's overkill. All you need is a single reference line that's located on the same point on each of the angled holders. Then you would scribe lines on the body those rotate on, marking at 0º, 30º, 45º and 60º. This allows you to make true diamond patterns of any angle, square, or straight knurls.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Knurling Vial Caps - by wrustle - 10-15-2013, 08:44 PM
RE: Knurling Vial Caps - by PixMan - 10-15-2013, 09:38 PM
RE: Knurling Vial Caps - by EdK - 10-16-2013, 06:03 AM
RE: Knurling Vial Caps - by PixMan - 10-16-2013, 06:54 AM
RE: Knurling Vial Caps - by EdK - 10-16-2013, 07:05 AM
RE: Knurling Vial Caps - by awemawson - 10-16-2013, 07:17 AM
RE: Knurling Vial Caps - by stevec - 10-16-2013, 07:17 AM
RE: Knurling Vial Caps - by EdK - 10-16-2013, 09:41 AM
RE: Knurling Vial Caps - by Mayhem - 10-16-2013, 09:08 AM
RE: Knurling Vial Caps - by DaveH - 10-16-2013, 12:43 PM
RE: Knurling Vial Caps - by stevec - 10-16-2013, 03:30 PM
RE: Knurling Vial Caps - by krv3000 - 10-17-2013, 03:47 PM
RE: Knurling Vial Caps - by PixMan - 10-17-2013, 06:11 PM
RE: Knurling Vial Caps - by wrustle - 10-18-2013, 09:35 PM
RE: Knurling Vial Caps - by LJP - 10-19-2013, 06:04 AM
RE: Knurling Vial Caps - by stevec - 10-19-2013, 06:11 AM
RE: Knurling Vial Caps - by wrustle - 10-19-2013, 07:05 AM
RE: Knurling Vial Caps - by DaveH - 10-19-2013, 06:32 AM
RE: Knurling Vial Caps - by EdK - 10-19-2013, 08:40 AM
RE: Knurling Vial Caps - by wrustle - 10-19-2013, 08:46 AM
RE: Knurling Vial Caps - by awemawson - 10-19-2013, 10:16 AM
RE: Knurling Vial Caps - by 12345678910 - 10-19-2013, 03:21 PM
RE: Knurling Vial Caps - by wrustle - 10-19-2013, 03:45 PM
RE: Knurling Vial Caps - by stevec - 10-19-2013, 06:25 PM
|
