10-11-2013, 03:56 PM
Willie,
It's tough to get end grain to match. If I had realized what you were doing sooner I would have suggested that you cut the dovetail on an angle so it went all the way through, then there would have been no end grain to match. I'm sure it will look fine once you get it oiled up.
Tom
It's tough to get end grain to match. If I had realized what you were doing sooner I would have suggested that you cut the dovetail on an angle so it went all the way through, then there would have been no end grain to match. I'm sure it will look fine once you get it oiled up.
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)