Colchester DRO
#4
Needle, I hesitate to suggest, but could you space the scale away from the cross slide enough to permit access without restricting tailstock movement toward the headstock too much?
I'd hate too find out months or years down the road that you're scuppered because the tailstock can't get close enough in. 17428
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Colchester DRO - by needleworks - 10-08-2013, 05:07 PM
RE: Colchester DRO - by f350ca - 10-08-2013, 06:36 PM
RE: Colchester DRO - by needleworks - 10-10-2013, 03:22 PM
RE: Colchester DRO - by stevec - 10-10-2013, 05:56 PM
RE: Colchester DRO - by needleworks - 10-11-2013, 01:40 PM
RE: Colchester DRO - by f350ca - 10-10-2013, 06:37 PM
RE: Colchester DRO - by stevec - 10-11-2013, 03:43 PM
RE: Colchester DRO - by PixMan - 10-12-2013, 01:23 PM
RE: Colchester DRO - by needleworks - 10-12-2013, 01:52 PM
RE: Colchester DRO - by paulmo101 - 10-27-2013, 02:48 PM
RE: Colchester DRO - by PixMan - 11-01-2013, 06:41 PM



Users browsing this thread: 1 Guest(s)