MetalworkingFun Forum › Machining › General Metalworking Discussion v
A Few Machines from my Workshop

Thread Modes
A Few Machines from my Workshop
awemawson Offline
Junior
****
Posts: 642
Threads: 14
Joined: Oct 2013
Location: East Sussex, UK
The following 1 user Likes awemawson's post:
oldgoaly (10-08-2013)
#17
10-08-2013, 03:01 AM
My Richmond 3 foot radial drill and my 18" shaper I've done little to restore as they were basically ok when I got them apart from sorting out damp in the motors and some dodgy wiring


Attached Files Thumbnail(s)
           
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:


Messages In This Thread
A Few Machines from my Workshop - by awemawson - 10-07-2013, 02:44 PM
RE: A Few Machines from my Workshop - by EdK - 10-07-2013, 05:02 PM
RE: A Few Machines from my Workshop - by TomG - 10-07-2013, 06:50 PM
RE: A Few Machines from my Workshop - by DaveH - 10-08-2013, 02:36 AM
RE: A Few Machines from my Workshop - by TomG - 10-08-2013, 07:11 AM
RE: A Few Machines from my Workshop - by awemawson - 10-08-2013, 03:01 AM
RE: A Few Machines from my Workshop - by LJP - 10-08-2013, 05:20 AM
RE: A Few Machines from my Workshop - by Mayhem - 10-08-2013, 09:34 AM
RE: A Few Machines from my Workshop - by PixMan - 10-08-2013, 09:35 AM
RE: A Few Machines from my Workshop - by DaveH - 10-08-2013, 10:43 AM
RE: A Few Machines from my Workshop - by oldgoaly - 10-08-2013, 02:57 PM
RE: A Few Machines from my Workshop - by Micktoon - 10-09-2013, 04:02 PM
RE: A Few Machines from my Workshop - by PixMan - 10-13-2013, 08:23 AM
RE: A Few Machines from my Workshop - by TomG - 10-13-2013, 09:50 AM



Users browsing this thread: 13 Guest(s)