MetalworkingFun Forum › Machinery › Milling Machines v
Powered drawbar?

Thread Modes
Powered drawbar?
oldgoaly Offline
Junior
****
Posts: 251
Threads: 21
Joined: Jun 2013
Location: Shiloh, Il. USA
#8
10-07-2013, 05:46 PM
I'm not sure how much torque I've have been putting on them the last year or two, knock on wood nothing has come out so far! I'll get some info off of it.later.
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.
Reply
Thanks given by:


Messages In This Thread
Powered drawbar? - by oldgoaly - 10-05-2013, 10:22 PM
RE: Powered drawbar? - by Highpower - 10-06-2013, 09:50 AM
RE: Powered drawbar? - by ScrapMetal - 10-06-2013, 07:10 PM
RE: Powered drawbar? - by oldgoaly - 10-06-2013, 08:18 PM
RE: Powered drawbar? - by Highpower - 10-06-2013, 11:09 PM
RE: Powered drawbar? - by oldgoaly - 10-07-2013, 02:45 PM
RE: Powered drawbar? - by Highpower - 10-07-2013, 04:58 PM
RE: Powered drawbar? - by oldgoaly - 10-07-2013, 05:46 PM
RE: Powered drawbar? - by oldgoaly - 10-10-2013, 09:37 PM
RE: Powered drawbar? - by Highpower - 10-10-2013, 11:14 PM
RE: Powered drawbar? - by oldgoaly - 10-11-2013, 12:19 AM



Users browsing this thread: 3 Guest(s)