10-07-2013, 02:45 PM
I've been looking at just about everything on the internet, sure a lot of crap / phoney sites!
Just to verify you don't need to hold the brake? would I be crazy to re-purpose a older battery impact? one they are cheap, a simple DC power supply, couple of momentary switches down low where they are easy to reach, a little wire? what money a power supply will cost make up in savings on air fittings and valves. some raise / lower the impact wrench, how about a brake cable and shop made foot pedal?
Just to verify you don't need to hold the brake? would I be crazy to re-purpose a older battery impact? one they are cheap, a simple DC power supply, couple of momentary switches down low where they are easy to reach, a little wire? what money a power supply will cost make up in savings on air fittings and valves. some raise / lower the impact wrench, how about a brake cable and shop made foot pedal?
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.