10-06-2013, 09:40 AM
(10-06-2013, 09:20 AM)Mayhem Wrote: Well that is the thing Ed - I could use a single drawbar by using any of the three other options I mentioned.
Having said that, I have the headroom to change drawbars and I would only need to change that when changing out the actual NTMB30 tool. So, the ER32 collet chuck would stay in place regardless of the endmill I would be using.
I guess what I was trying to say, and didn't do too well, was except for option 1 the other two options would require about the same amount of work in actual use since both would require removing the draw bar to change to the correct threaded end for the tool.
Ed