MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
Multiple Drawbar / Arbour Threads

Thread Modes
Multiple Drawbar / Arbour Threads
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#2
10-06-2013, 05:30 AM (This post was last modified: 10-06-2013, 05:31 AM by stevec.)
I don't think option 2 would work, 12mm is only 26thou under ½".

Option 3 sounds best but you might need three adaptors of the correct length to be able to use one drawbar.

I'd prolly go with 3 drawbars. (well marked!) 17428
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by: Mayhem


Messages In This Thread
Multiple Drawbar / Arbour Threads - by Mayhem - 10-06-2013, 03:23 AM
RE: Multiple Drawbar / Arbour Threads - by stevec - 10-06-2013, 05:30 AM
RE: Multiple Drawbar / Arbour Threads - by Mayhem - 10-06-2013, 05:44 AM
RE: Multiple Drawbar / Arbour Threads - by EdK - 10-06-2013, 09:11 AM
RE: Multiple Drawbar / Arbour Threads - by Mayhem - 10-06-2013, 09:20 AM
RE: Multiple Drawbar / Arbour Threads - by EdK - 10-06-2013, 09:40 AM
RE: Multiple Drawbar / Arbour Threads - by Mayhem - 10-06-2013, 09:47 AM
RE: Multiple Drawbar / Arbour Threads - by stevec - 10-06-2013, 03:56 PM
RE: Multiple Drawbar / Arbour Threads - by EdK - 10-06-2013, 10:51 AM
RE: Multiple Drawbar / Arbour Threads - by EdK - 10-06-2013, 04:48 PM
RE: Multiple Drawbar / Arbour Threads - by Mayhem - 10-06-2013, 05:47 PM
RE: Multiple Drawbar / Arbour Threads - by EdK - 10-06-2013, 06:27 PM
RE: Multiple Drawbar / Arbour Threads - by dallen - 10-07-2013, 03:00 PM
RE: Multiple Drawbar / Arbour Threads - by Mayhem - 10-07-2013, 05:51 PM
RE: Multiple Drawbar / Arbour Threads - by Mayhem - 05-05-2016, 06:41 AM



Users browsing this thread: 8 Guest(s)