MetalworkingFun Forum › Machining › General Metalworking Discussion v
Rust on my rounds....

Thread Modes
Rust on my rounds....
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#9
10-02-2013, 01:18 AM
Greg if you take a look at my shaper thread you will see the parts I zapped. The rusty areas will be black/grey afterwards but will polish up. I'm posting on my phone right now, otherwise I would link to the post/pics
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Rust on my rounds.... - by ieezitin - 09-30-2013, 06:41 PM
RE: Rust on my rounds.... - by chucketn - 09-30-2013, 07:07 PM
RE: Rust on my rounds.... - by ScrapMetal - 09-30-2013, 09:37 PM
RE: Rust on my rounds.... - by oldgoaly - 09-30-2013, 10:57 PM
RE: Rust on my rounds.... - by TomG - 10-01-2013, 09:12 PM
RE: Rust on my rounds.... - by ScrapMetal - 10-02-2013, 09:24 PM
RE: Rust on my rounds.... - by f350ca - 10-01-2013, 10:56 PM
RE: Rust on my rounds.... - by TomG - 10-01-2013, 11:07 PM
RE: Rust on my rounds.... - by f350ca - 10-02-2013, 12:10 AM
RE: Rust on my rounds.... - by Mayhem - 10-02-2013, 01:18 AM
RE: Rust on my rounds.... - by rleete - 10-03-2013, 08:32 PM
RE: Rust on my rounds.... - by Mayhem - 10-04-2013, 07:10 AM



Users browsing this thread: 2 Guest(s)