10-01-2013, 07:11 AM
Thanks Tom - Ken just walked me through this last week and this has just reinforced what he said.
One question (that I didn't think of last week) is what do you do if your machine cannot reach the calculated speed? For example, there is no way I could spin a 1/8" endmill at the 9600 rpm needed for brass. Or what if your mill couldn't go slow enough for the 6" slitting saw you have there?
One question (that I didn't think of last week) is what do you do if your machine cannot reach the calculated speed? For example, there is no way I could spin a 1/8" endmill at the 9600 rpm needed for brass. Or what if your mill couldn't go slow enough for the 6" slitting saw you have there?
Hunting American dentists since 2015.