MetalworkingFun Forum › Machining › General Metalworking Discussion v
Rust on my rounds....

Thread Modes
Rust on my rounds....
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#2
09-30-2013, 07:07 PM
I use a saturated solution of vinegar and table salt. You must apply some form of protection immediately after cleaning the items when removed from the vinegar solution or flash rusting will occur.
I prefer this method to electrolysis.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Rust on my rounds.... - by ieezitin - 09-30-2013, 06:41 PM
RE: Rust on my rounds.... - by chucketn - 09-30-2013, 07:07 PM
RE: Rust on my rounds.... - by ScrapMetal - 09-30-2013, 09:37 PM
RE: Rust on my rounds.... - by oldgoaly - 09-30-2013, 10:57 PM
RE: Rust on my rounds.... - by TomG - 10-01-2013, 09:12 PM
RE: Rust on my rounds.... - by ScrapMetal - 10-02-2013, 09:24 PM
RE: Rust on my rounds.... - by f350ca - 10-01-2013, 10:56 PM
RE: Rust on my rounds.... - by TomG - 10-01-2013, 11:07 PM
RE: Rust on my rounds.... - by f350ca - 10-02-2013, 12:10 AM
RE: Rust on my rounds.... - by Mayhem - 10-02-2013, 01:18 AM
RE: Rust on my rounds.... - by rleete - 10-03-2013, 08:32 PM
RE: Rust on my rounds.... - by Mayhem - 10-04-2013, 07:10 AM



Users browsing this thread: 2 Guest(s)