MetalworkingFun Forum › Machining › Welding & Casting v
Molding Bench

Thread Modes
Molding Bench
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#18
09-26-2013, 05:22 PM
DA, I plan on using drywall screws, 2 x 4's with lap joints and
glue to make my frame.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Molding Bench - by chucketn - 09-25-2013, 06:28 PM
RE: Molding Bench - by f350ca - 09-25-2013, 07:22 PM
RE: Molding Bench - by chucketn - 09-25-2013, 07:47 PM
RE: Molding Bench - by oldgoaly - 09-25-2013, 07:51 PM
RE: Molding Bench - by chucketn - 09-25-2013, 07:54 PM
RE: Molding Bench - by oldgoaly - 09-25-2013, 08:13 PM
RE: Molding Bench - by f350ca - 09-25-2013, 08:29 PM
RE: Molding Bench - by chucketn - 09-26-2013, 07:14 AM
RE: Molding Bench - by dallen - 09-26-2013, 07:43 AM
RE: Molding Bench - by chucketn - 09-26-2013, 08:31 AM
RE: Molding Bench - by oldgoaly - 09-26-2013, 10:11 AM
RE: Molding Bench - by dallen - 09-26-2013, 10:23 AM
RE: Molding Bench - by chucketn - 09-26-2013, 10:45 AM
RE: Molding Bench - by oldgoaly - 09-26-2013, 01:12 PM
RE: Molding Bench - by doubleboost - 09-26-2013, 02:28 PM
RE: Molding Bench - by chucketn - 09-26-2013, 03:14 PM
RE: Molding Bench - by dallen - 09-26-2013, 05:08 PM
RE: Molding Bench - by chucketn - 09-26-2013, 05:22 PM



Users browsing this thread: 3 Guest(s)