MetalworkingFun Forum › Machining › General Metalworking Discussion v
I bought a mill!

Thread Modes
I bought a mill!
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#12
04-15-2012, 05:16 PM
Appologies due here, apparently I spell "Nitsuj" B o b. Hey ya gotta admit it's easier.
Sorry Bob my post shoulda been addressed to Nitsuj.
Steve
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
I bought a mill! - by Nitsuj - 04-14-2012, 07:30 PM
RE: I bought a mill! - by ETC57 - 04-14-2012, 07:38 PM
RE: I bought a mill! - by EdK - 04-14-2012, 07:55 PM
RE: I bought a mill! - by Mayhem - 04-14-2012, 09:55 PM
RE: I bought a mill! - by Highpower - 04-14-2012, 09:57 PM
RE: I bought a mill! - by lazylathe - 04-14-2012, 10:02 PM
RE: I bought a mill! - by DaveH - 04-15-2012, 06:39 AM
RE: I bought a mill! - by Nitsuj - 04-15-2012, 10:03 AM
RE: I bought a mill! - by aametalmaster - 04-15-2012, 10:38 AM
RE: I bought a mill! - by stevec - 04-15-2012, 03:16 PM
RE: I bought a mill! - by aametalmaster - 04-15-2012, 03:37 PM
RE: I bought a mill! - by Highpower - 04-15-2012, 07:09 PM
RE: I bought a mill! - by stevec - 04-15-2012, 05:16 PM
RE: I bought a mill! - by aametalmaster - 04-15-2012, 06:44 PM
RE: I bought a mill! - by stevec - 04-15-2012, 07:28 PM
RE: I bought a mill! - by Nitsuj - 04-16-2012, 11:12 AM
RE: I bought a mill! - by Highpower - 04-16-2012, 11:33 AM
RE: I bought a mill! - by EdK - 04-16-2012, 11:44 AM



Users browsing this thread: 4 Guest(s)