MetalworkingFun Forum › Machining › Welding & Casting v
Molding Bench

Thread Modes
Molding Bench
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#5
09-25-2013, 07:54 PM
(09-25-2013, 07:51 PM)oldgoaly Wrote: Chuck my old molding bench is made from a cabinet from a science lab, you probably seen them, what I did was line it with metal, 26 gauge cause it doesn't need to be to thick. then used 2 by 2 for the slats. My newer bench is a mifco that was missing a door, I just made a 26 gauge one to keep the cat or mice out. If you would like pics just ask I'll be happy to post them.

oldgoaly, what are the dimentions of your bench? Are you happy with it? What would you do different. And lastly, do you keep used sand separate from the conditioned sand?

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Molding Bench - by chucketn - 09-25-2013, 06:28 PM
RE: Molding Bench - by f350ca - 09-25-2013, 07:22 PM
RE: Molding Bench - by chucketn - 09-25-2013, 07:47 PM
RE: Molding Bench - by oldgoaly - 09-25-2013, 07:51 PM
RE: Molding Bench - by chucketn - 09-25-2013, 07:54 PM
RE: Molding Bench - by oldgoaly - 09-25-2013, 08:13 PM
RE: Molding Bench - by f350ca - 09-25-2013, 08:29 PM
RE: Molding Bench - by chucketn - 09-26-2013, 07:14 AM
RE: Molding Bench - by dallen - 09-26-2013, 07:43 AM
RE: Molding Bench - by chucketn - 09-26-2013, 08:31 AM
RE: Molding Bench - by oldgoaly - 09-26-2013, 10:11 AM
RE: Molding Bench - by dallen - 09-26-2013, 10:23 AM
RE: Molding Bench - by chucketn - 09-26-2013, 10:45 AM
RE: Molding Bench - by oldgoaly - 09-26-2013, 01:12 PM
RE: Molding Bench - by doubleboost - 09-26-2013, 02:28 PM
RE: Molding Bench - by chucketn - 09-26-2013, 03:14 PM
RE: Molding Bench - by dallen - 09-26-2013, 05:08 PM
RE: Molding Bench - by chucketn - 09-26-2013, 05:22 PM



Users browsing this thread: 1 Guest(s)