|
Molding Bench
|
09-25-2013, 07:51 PM
Chuck my old molding bench is made from a cabinet from a science lab, you probably seen them, what I did was line it with metal, 26 gauge cause it doesn't need to be to thick. then used 2 by 2 for the slats. My newer bench is a mifco that was missing a door, I just made a 26 gauge one to keep the cat or mice out. If you would like pics just ask I'll be happy to post them.
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Molding Bench - by chucketn - 09-25-2013, 06:28 PM
RE: Molding Bench - by f350ca - 09-25-2013, 07:22 PM
RE: Molding Bench - by chucketn - 09-25-2013, 07:47 PM
RE: Molding Bench - by oldgoaly - 09-25-2013, 07:51 PM
RE: Molding Bench - by chucketn - 09-25-2013, 07:54 PM
RE: Molding Bench - by oldgoaly - 09-25-2013, 08:13 PM
RE: Molding Bench - by f350ca - 09-25-2013, 08:29 PM
RE: Molding Bench - by chucketn - 09-26-2013, 07:14 AM
RE: Molding Bench - by dallen - 09-26-2013, 07:43 AM
RE: Molding Bench - by chucketn - 09-26-2013, 08:31 AM
RE: Molding Bench - by oldgoaly - 09-26-2013, 10:11 AM
RE: Molding Bench - by dallen - 09-26-2013, 10:23 AM
RE: Molding Bench - by chucketn - 09-26-2013, 10:45 AM
RE: Molding Bench - by oldgoaly - 09-26-2013, 01:12 PM
RE: Molding Bench - by doubleboost - 09-26-2013, 02:28 PM
RE: Molding Bench - by chucketn - 09-26-2013, 03:14 PM
RE: Molding Bench - by dallen - 09-26-2013, 05:08 PM
RE: Molding Bench - by chucketn - 09-26-2013, 05:22 PM
|
