09-21-2013, 03:20 PM
Trim your wire stick out where you like it each time before you strike the next arc. Depending what part i am welding at work i usually break my wire flush with the tip then tap the trigger so its there. But i am using gas flux core and it really doesn't like to start on the ball in the wire end...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...