|
Help Welding Table Thickness
|
09-17-2013, 08:51 PM
A shop I used to work in had one 4" x 6' x 1" thick. We used it for everything from fixturing parts to beating things into submission. The 1" thickness was nice for the mass, because you didn't need to worry about it moving around when you were working on it.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) Thanks given by: EdK
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Welding Table Thickness - by EdK - 09-17-2013, 07:08 PM
RE: Welding Table Thickness - by Mayhem - 09-17-2013, 07:43 PM
RE: Welding Table Thickness - by f350ca - 09-17-2013, 08:19 PM
RE: Welding Table Thickness - by EdK - 09-17-2013, 08:24 PM
RE: Welding Table Thickness - by Mayhem - 09-17-2013, 08:40 PM
RE: Welding Table Thickness - by EdK - 09-18-2013, 05:36 AM
RE: Welding Table Thickness - by mattinker - 09-18-2013, 05:52 AM
RE: Welding Table Thickness - by TomG - 09-17-2013, 08:51 PM
RE: Welding Table Thickness - by dallen - 09-17-2013, 09:15 PM
RE: Welding Table Thickness - by arvidj - 09-17-2013, 09:16 PM
RE: Welding Table Thickness - by EdK - 09-18-2013, 05:58 AM
RE: Welding Table Thickness - by stevec - 09-18-2013, 06:58 AM
RE: Welding Table Thickness - by Mayhem - 09-18-2013, 10:51 AM
RE: Welding Table Thickness - by stevec - 09-18-2013, 11:30 AM
RE: Welding Table Thickness - by EdK - 09-18-2013, 11:47 AM
RE: Welding Table Thickness - by oldgoaly - 09-18-2013, 12:33 PM
RE: Welding Table Thickness - by Mayhem - 09-18-2013, 03:09 PM
RE: Welding Table Thickness - by doubleboost - 09-18-2013, 04:03 PM
RE: Welding Table Thickness - by stevec - 09-18-2013, 06:22 PM
RE: Welding Table Thickness - by Mayhem - 09-19-2013, 01:23 AM
|
