L to R. 1.co2 injector to run off ''pub gas'' from a modified blow gun with a hollow needle.
2.pattern removal screws.
3.&4. ingate cutters.
5. various ball bearings brazed to rods for smoothing the bottom of ingates/sprues,patterns etc.
6.fork[cast brass] for quick rapping patterns in conjunction with a spike.[would also make a good catty]slingshot to our cousins across the atlantic he he.
7.back.ingate patterns,put at the bottom of ingate.
Bottom. sand rammer with cast head pressed onto a cut down chisel bit from a modified air chisel.
the artfull-codger, proud to be a member of MetalworkingFun Forum since Feb 2013.