MetalworkingFun Forum › Machining › Projects v
Soft jaws for a 3 jaw chuck

Thread Modes
Soft jaws for a 3 jaw chuck
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#10
09-15-2013, 10:27 PM
I thought this was a project I suggested annealing the jaws in but I responded to the post on the other thread whilst on my phone, so couldn't be arsed going to look for it Big Grin

Once again, nice job Steve!
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Soft jaws for a 3 jaw chuck - by stevec - 09-15-2013, 07:21 AM
RE: Soft jaws for a 3 jaw chuck - by EdK - 09-15-2013, 08:14 AM
RE: Soft jaws for a 3 jaw chuck - by Highpower - 09-15-2013, 09:56 AM
RE: Soft jaws for a 3 jaw chuck - by EdK - 09-15-2013, 03:42 PM
RE: Soft jaws for a 3 jaw chuck - by stevec - 09-15-2013, 03:46 PM
RE: Soft jaws for a 3 jaw chuck - by stevec - 09-15-2013, 03:22 PM
RE: Soft jaws for a 3 jaw chuck - by EdK - 09-15-2013, 03:36 PM
RE: Soft jaws for a 3 jaw chuck - by stevec - 09-15-2013, 03:47 PM
RE: Soft jaws for a 3 jaw chuck - by EdK - 09-15-2013, 04:31 PM
RE: Soft jaws for a 3 jaw chuck - by Mayhem - 09-15-2013, 10:27 PM



Users browsing this thread: 1 Guest(s)