flat belt pulley pattern

[dallen]

Thanks John, I screwed it up with the hub on the inside when I measured it I measured from the column to the edge of the pulley rim and then didn't think anything else about it, but when I put in the inner part of the hub it pushed the whole pulley out and inch which put things out of alignment. but I think I've cheated enough that it will be ok,

I think next up should be a nice pulley to replace the one on the tranny as from the looks of it I think it's made from paper (some of them were) I think a nice 6 inch diameter 3.5 wide pulley might make a really nice iron pour.

DA