Gas Not Getting To Nozzle

[EdK]

(09-15-2013, 12:48 PM)f350ca Wrote: First thing that comes to mind Ed is a setting on the welder. Mine is processor controlled if I set it for flux core wire the solenoid gas valve doesn't operate. Check the manual for a setting or switch.
If thats not the case see if there is a connector that feeds gas to the lead, open it and see if the gas is getting that far. I've had trouble with the cover on a new liner separating and blocking the flow in the lead.

Thanks Greg. Time to do some exploratory surgery. The warranty has run out on it so no worries about voiding the warranty.

Ed