09-15-2013, 12:48 PM
First thing that comes to mind Ed is a setting on the welder. Mine is processor controlled if I set it for flux core wire the solenoid gas valve doesn't operate. Check the manual for a setting or switch.
If thats not the case see if there is a connector that feeds gas to the lead, open it and see if the gas is getting that far. I've had trouble with the cover on a new liner separating and blocking the flow in the lead.
If thats not the case see if there is a connector that feeds gas to the lead, open it and see if the gas is getting that far. I've had trouble with the cover on a new liner separating and blocking the flow in the lead.
Free advice is worth exactly what you payed for it.
Greg
Greg