MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lubrication oils

Thread Modes
Lubrication oils
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#20
04-14-2012, 08:01 AM
John, you are correct. The x-feed gearbox holds a little oil in the bottom section where the shaft bearings and thrust bearing and the lower gears are located. The majority of the gears rely upon splash lubrication.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Lubrication oils - by Mayhem - 03-15-2012, 08:37 AM
RE: Lubrication oils - by DaveH - 03-15-2012, 10:09 AM
RE: Lubrication oils - by Mayhem - 03-15-2012, 10:17 AM
RE: Lubrication oils - by EdK - 03-15-2012, 01:09 PM
RE: Lubrication oils - by B34VD - 03-15-2012, 04:36 PM
RE: Lubrication oils - by Mayhem - 03-15-2012, 07:13 PM
RE: Lubrication oils - by PixMan - 03-16-2012, 06:47 AM
RE: Lubrication oils - by stevec - 03-16-2012, 07:47 AM
RE: Lubrication oils - by Mayhem - 03-16-2012, 07:56 AM
RE: Lubrication oils - by stevec - 03-16-2012, 01:26 PM
RE: Lubrication oils - by Bogstandard - 03-30-2012, 01:52 AM
RE: Lubrication oils - by Mayhem - 03-30-2012, 04:30 AM
RE: Lubrication oils - by EdK - 03-30-2012, 07:06 AM
RE: Lubrication oils - by Bogstandard - 03-30-2012, 09:56 AM
RE: Lubrication oils - by EdK - 03-30-2012, 10:21 AM
RE: Lubrication oils - by Mayhem - 04-12-2012, 10:50 PM
RE: Lubrication oils - by Hopefuldave - 04-13-2012, 01:47 PM
RE: Lubrication oils - by Mayhem - 04-13-2012, 07:20 PM
RE: Lubrication oils - by Bogstandard - 04-14-2012, 03:38 AM
RE: Lubrication oils - by EdK - 04-14-2012, 04:47 PM
RE: Lubrication oils - by Mayhem - 04-14-2012, 08:01 AM
RE: Lubrication oils - by Bogstandard - 04-14-2012, 06:43 PM
RE: Lubrication oils - by Hopefuldave - 04-15-2012, 06:55 AM
RE: Lubrication oils - by Mayhem - 04-14-2012, 08:00 PM
RE: Lubrication oils - by EdK - 04-14-2012, 08:05 PM
RE: Lubrication oils - by Mayhem - 04-14-2012, 08:18 PM
RE: Lubrication oils - by Highpower - 04-14-2012, 10:04 PM



Users browsing this thread: 2 Guest(s)