Looks like we have a workable saw. Haven't tested it yet, the bucket is on the tractor and the timbers are no where near a plug-in, dam electric chain saws.
![[Image: IMG_0743.jpg]](https://lh4.googleusercontent.com/-Az86AqWPw50/UijxGIVfW8I/AAAAAAAABcA/J9vDaypuAEQ/s1280/IMG_0743.jpg)
Drilled the bar and mounted it to the base.
![[Image: IMG_0745.jpg]](https://lh4.googleusercontent.com/-jPHl2xrT77I/UijxEa2-uwI/AAAAAAAABb0/MirX7z6Jvp0/s1280/IMG_0745.jpg)
May need to find a beter piece of angle iron for the guide, this one has a small bend at the end.
![[Image: IMG_0747.jpg]](https://lh4.googleusercontent.com/-29ToS2pi57I/UijxGYpCpVI/AAAAAAAABcE/6bXMLlt_sak/s912/IMG_0747.jpg)
Saw mounted.
![[Image: IMG_0748.jpg]](https://lh3.googleusercontent.com/-wmKwrpzbVoc/UijxHK32_8I/AAAAAAAABcM/EivRN02srW0/s912/IMG_0748.jpg)
seams to have a good balance, but may need to open up the slot the bar goes through to beter see the cut.
Drilled the bar and mounted it to the base.
May need to find a beter piece of angle iron for the guide, this one has a small bend at the end.
Saw mounted.
seams to have a good balance, but may need to open up the slot the bar goes through to beter see the cut.
Free advice is worth exactly what you payed for it.
Greg
Greg