Lubrication oils
#16
Picked up some ISO32 and I was surprised at how thin it was. I actually had to check that it wasn't water, as it is clear!

I was given a couple of cans of open gear spray and tried it out recently when threading. I thought it was good and quietened the gear train noise quite a bit. I plan to make a cover for my gears and they are covered whenever the lathe is not in use. Fortunately the gears are far enough away from the chuck that I am not getting chips back there. I am planning on making a box to store my change gears in, so they stay clean between changes. The only place I need to oil is the shafts that the change gears and the tumbler gears run on.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Lubrication oils - by Mayhem - 03-15-2012, 08:37 AM
RE: Lubrication oils - by DaveH - 03-15-2012, 10:09 AM
RE: Lubrication oils - by Mayhem - 03-15-2012, 10:17 AM
RE: Lubrication oils - by EdK - 03-15-2012, 01:09 PM
RE: Lubrication oils - by B34VD - 03-15-2012, 04:36 PM
RE: Lubrication oils - by Mayhem - 03-15-2012, 07:13 PM
RE: Lubrication oils - by PixMan - 03-16-2012, 06:47 AM
RE: Lubrication oils - by stevec - 03-16-2012, 07:47 AM
RE: Lubrication oils - by Mayhem - 03-16-2012, 07:56 AM
RE: Lubrication oils - by stevec - 03-16-2012, 01:26 PM
RE: Lubrication oils - by Bogstandard - 03-30-2012, 01:52 AM
RE: Lubrication oils - by Mayhem - 03-30-2012, 04:30 AM
RE: Lubrication oils - by EdK - 03-30-2012, 07:06 AM
RE: Lubrication oils - by Bogstandard - 03-30-2012, 09:56 AM
RE: Lubrication oils - by EdK - 03-30-2012, 10:21 AM
RE: Lubrication oils - by Mayhem - 04-12-2012, 10:50 PM
RE: Lubrication oils - by Hopefuldave - 04-13-2012, 01:47 PM
RE: Lubrication oils - by Mayhem - 04-13-2012, 07:20 PM
RE: Lubrication oils - by Bogstandard - 04-14-2012, 03:38 AM
RE: Lubrication oils - by EdK - 04-14-2012, 04:47 PM
RE: Lubrication oils - by Mayhem - 04-14-2012, 08:01 AM
RE: Lubrication oils - by Bogstandard - 04-14-2012, 06:43 PM
RE: Lubrication oils - by Hopefuldave - 04-15-2012, 06:55 AM
RE: Lubrication oils - by Mayhem - 04-14-2012, 08:00 PM
RE: Lubrication oils - by EdK - 04-14-2012, 08:05 PM
RE: Lubrication oils - by Mayhem - 04-14-2012, 08:18 PM
RE: Lubrication oils - by Highpower - 04-14-2012, 10:04 PM



Users browsing this thread: 2 Guest(s)