09-04-2013, 11:21 PM
I run the indicator up & down to find the high point of the radius and side-to-side to find the low point of the straight at centerline, then adjust the Y axis until the readings are equal.
|
Centering Over Round Piece
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Centering Over Round Piece - by EdK - 09-04-2013, 11:51 AM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 12:10 PM
RE: Centering Over Round Piece - by PixMan - 09-04-2013, 12:43 PM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 12:56 PM
RE: Centering Over Round Piece - by dallen - 09-04-2013, 03:45 PM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 04:01 PM
RE: Centering Over Round Piece - by Highpower - 09-04-2013, 08:17 PM
RE: Centering Over Round Piece - by TomG - 09-04-2013, 10:56 PM
RE: Centering Over Round Piece - by PixMan - 09-04-2013, 11:21 PM
RE: Centering Over Round Piece - by Sunset Machine - 09-05-2013, 07:39 AM
RE: Centering Over Round Piece - by EdK - 09-05-2013, 08:30 AM
|
Users browsing this thread: 2 Guest(s)