09-04-2013, 10:56 PM
Ed,
You can also use an dial test indicator to center a part. Just swing the indicator on each side of the part and adjust the table until it reads the same on each side. If you do it on a piece of tubing, set your quill stop so you can set the indicator to the same level in Z on both sides of the tube (preferably at the center).
Tom
You can also use an dial test indicator to center a part. Just swing the indicator on each side of the part and adjust the table until it reads the same on each side. If you do it on a piece of tubing, set your quill stop so you can set the indicator to the same level in Z on both sides of the tube (preferably at the center).
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)