MetalworkingFun Forum › Machining › General Metalworking Discussion v
Centering Over Round Piece

Thread Modes
Centering Over Round Piece
Highpower Offline
JAFO
******
Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#7
09-04-2013, 08:17 PM
I do this:





But I use a full diameter 1/2" center finder and leave the .200" tip for small diameters.

[Image: 0203524-23.jpg]

Blink
Willie
Reply
Thanks given by: EdK


Messages In This Thread
Centering Over Round Piece - by EdK - 09-04-2013, 11:51 AM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 12:10 PM
RE: Centering Over Round Piece - by PixMan - 09-04-2013, 12:43 PM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 12:56 PM
RE: Centering Over Round Piece - by dallen - 09-04-2013, 03:45 PM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 04:01 PM
RE: Centering Over Round Piece - by Highpower - 09-04-2013, 08:17 PM
RE: Centering Over Round Piece - by TomG - 09-04-2013, 10:56 PM
RE: Centering Over Round Piece - by PixMan - 09-04-2013, 11:21 PM
RE: Centering Over Round Piece - by EdK - 09-05-2013, 08:30 AM



Users browsing this thread: 3 Guest(s)