MetalworkingFun Forum › Machining › General Metalworking Discussion v
Centering Over Round Piece

Thread Modes
Centering Over Round Piece
EdK Offline
Whipping Boy
*******
Posts: 8,854
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
#6
09-04-2013, 04:01 PM
(09-04-2013, 03:45 PM)dallen Wrote: finding center is easy once you get it lined up on the mill table so that its straight. I take that the holes have to be in alignment to the center of the tube right

DA

Correct.

Ed
Reply
Thanks given by:


Messages In This Thread
Centering Over Round Piece - by EdK - 09-04-2013, 11:51 AM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 12:10 PM
RE: Centering Over Round Piece - by PixMan - 09-04-2013, 12:43 PM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 12:56 PM
RE: Centering Over Round Piece - by dallen - 09-04-2013, 03:45 PM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 04:01 PM
RE: Centering Over Round Piece - by Highpower - 09-04-2013, 08:17 PM
RE: Centering Over Round Piece - by TomG - 09-04-2013, 10:56 PM
RE: Centering Over Round Piece - by PixMan - 09-04-2013, 11:21 PM
RE: Centering Over Round Piece - by EdK - 09-05-2013, 08:30 AM



Users browsing this thread: 2 Guest(s)