|
Centering Over Round Piece
|
09-04-2013, 03:45 PM
finding center is easy once you get it lined up on the mill table so that its straight. I take that the holes have to be in alignment to the center of the tube right
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Centering Over Round Piece - by EdK - 09-04-2013, 11:51 AM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 12:10 PM
RE: Centering Over Round Piece - by PixMan - 09-04-2013, 12:43 PM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 12:56 PM
RE: Centering Over Round Piece - by dallen - 09-04-2013, 03:45 PM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 04:01 PM
RE: Centering Over Round Piece - by Highpower - 09-04-2013, 08:17 PM
RE: Centering Over Round Piece - by TomG - 09-04-2013, 10:56 PM
RE: Centering Over Round Piece - by PixMan - 09-04-2013, 11:21 PM
RE: Centering Over Round Piece - by Sunset Machine - 09-05-2013, 07:39 AM
RE: Centering Over Round Piece - by EdK - 09-05-2013, 08:30 AM
|
