MetalworkingFun Forum › Machining › General Metalworking Discussion v
Turning an Impact Socket

Thread Modes
Turning an Impact Socket
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#3
09-03-2013, 05:30 PM
(09-03-2013, 04:58 PM)doubleboost Wrote: Just use a tip tool
Sockets are tough not hard
John

Thanks John. By "tip tool" are you talking about a carbide insert tool?

Ed
Reply
Thanks given by:


Messages In This Thread
Turning an Impact Socket - by EdK - 09-03-2013, 04:54 PM
RE: Turning an Impact Socket - by doubleboost - 09-03-2013, 04:58 PM
RE: Turning an Impact Socket - by EdK - 09-03-2013, 05:30 PM
RE: Turning an Impact Socket - by PixMan - 09-03-2013, 05:34 PM
RE: Turning an Impact Socket - by the penguin - 09-04-2013, 07:24 PM
RE: Turning an Impact Socket - by PixMan - 09-04-2013, 11:22 PM



Users browsing this thread: 1 Guest(s)