MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
question about my rt

Thread Modes
question about my rt
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#4
04-12-2012, 06:24 PM
Wait guys, if I read correctly he's not arguing about how many degrees are in a circle, he said :-

(04-12-2012, 01:30 PM)ETC57 Wrote: As you can see my rt dose not fit squarely on my little mill.

JerryPopcorn

P.S. All helpful input is welcome please.Worthy
Jerry, I'm sorry but from that photo I cannot see that your rt does not fit squarely on your machine. Please elaborate.
Steve
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
question about my rt - by ETC57 - 04-12-2012, 01:30 PM
RE: question about my rt - by EdK - 04-12-2012, 01:39 PM
RE: question about my rt - by Highpower - 04-12-2012, 03:03 PM
RE: question about my rt - by stevec - 04-12-2012, 06:24 PM
RE: question about my rt - by Highpower - 04-12-2012, 08:58 PM
RE: question about my rt - by ETC57 - 04-12-2012, 09:23 PM
RE: question about my rt - by Highpower - 04-12-2012, 09:43 PM
RE: question about my rt - by ETC57 - 04-12-2012, 10:57 PM
RE: question about my rt - by DaveH - 04-13-2012, 02:27 AM
RE: question about my rt - by f350ca - 04-13-2012, 08:46 AM
RE: question about my rt - by stevec - 04-13-2012, 10:14 AM



Users browsing this thread: 3 Guest(s)