MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
question about my rt

Thread Modes
question about my rt
EdK Offline
Whipping Boy
*******
Posts: 8,861
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#2
04-12-2012, 01:39 PM
Jerry,

With 360 tick marks that would indicate they're 1 degrees per tick mark so yes, 180 would be half way, 90 = 1/4 way, 270 = 3/4 way, etc....

Ed
Reply
Thanks given by:


Messages In This Thread
question about my rt - by ETC57 - 04-12-2012, 01:30 PM
RE: question about my rt - by EdK - 04-12-2012, 01:39 PM
RE: question about my rt - by Highpower - 04-12-2012, 03:03 PM
RE: question about my rt - by stevec - 04-12-2012, 06:24 PM
RE: question about my rt - by Highpower - 04-12-2012, 08:58 PM
RE: question about my rt - by ETC57 - 04-12-2012, 09:23 PM
RE: question about my rt - by Highpower - 04-12-2012, 09:43 PM
RE: question about my rt - by ETC57 - 04-12-2012, 10:57 PM
RE: question about my rt - by DaveH - 04-13-2012, 02:27 AM
RE: question about my rt - by f350ca - 04-13-2012, 08:46 AM
RE: question about my rt - by stevec - 04-13-2012, 10:14 AM



Users browsing this thread: 7 Guest(s)