04-12-2012, 01:30 PM
Hi all,
So my question is regarding the divisions at the base of my rt, they are from 0 to 0 360 divisions.
So am I correct in assuming that 180 is 1/2 way around and so on?
The reason I ask is I have to make a bushing out of round stock and 1/3 of the way down the od needs to be 11/16" hex.
As you can see my rt dose not fit squarely on my little mill.
Jerry
P.S. All helpful input is welcome please.
So my question is regarding the divisions at the base of my rt, they are from 0 to 0 360 divisions.
So am I correct in assuming that 180 is 1/2 way around and so on?
The reason I ask is I have to make a bushing out of round stock and 1/3 of the way down the od needs to be 11/16" hex.
As you can see my rt dose not fit squarely on my little mill.
Jerry
P.S. All helpful input is welcome please.
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.