MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
16° Tangential Tool Holder

Thread Modes
16° Tangential Tool Holder
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#3
08-29-2013, 02:39 PM
The one I just built for my 7x works great. I also used 1"x1" CRS bar, and made it to fit my OXA QCTP. Haven't used it much, but happy with the rigidity. Will soon try a small radius on the cutting tip.
What prompted 16 deg?
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
16° Tangential Tool Holder - by LJP - 08-29-2013, 07:10 AM
RE: 16° Tangential Tool Holder - by EdK - 08-29-2013, 11:35 AM
RE: 16° Tangential Tool Holder - by chucketn - 08-29-2013, 02:39 PM
RE: 16° Tangential Tool Holder - by DaveH - 08-29-2013, 03:06 PM
RE: 16° Tangential Tool Holder - by LJP - 08-29-2013, 03:27 PM
RE: 16° Tangential Tool Holder - by doubleboost - 08-29-2013, 04:12 PM
RE: 16° Tangential Tool Holder - by chucketn - 08-29-2013, 05:51 PM
RE: 16° Tangential Tool Holder - by stevec - 08-29-2013, 06:07 PM
RE: 16° Tangential Tool Holder - by MikeWi - 08-29-2013, 11:57 PM
RE: 16° Tangential Tool Holder - by f350ca - 08-29-2013, 07:51 PM
RE: 16° Tangential Tool Holder - by Rickabilly - 08-30-2013, 12:46 AM
RE: 16° Tangential Tool Holder - by Rickabilly - 08-30-2013, 01:35 PM
RE: 16° Tangential Tool Holder - by LJP - 08-31-2013, 03:16 AM
RE: 16° Tangential Tool Holder - by Rickabilly - 08-31-2013, 10:53 PM
RE: 16° Tangential Tool Holder - by Mayhem - 08-31-2013, 11:08 PM
RE: 16° Tangential Tool Holder - by EdK - 09-02-2013, 10:19 AM
RE: 16° Tangential Tool Holder - by Rickabilly - 08-31-2013, 11:12 PM
RE: 16° Tangential Tool Holder - by LJP - 09-01-2013, 03:49 AM
RE: 16° Tangential Tool Holder - by Rickabilly - 09-01-2013, 10:17 AM
RE: 16° Tangential Tool Holder - by Mayhem - 09-02-2013, 10:21 AM



Users browsing this thread: 10 Guest(s)