flat belt pulley pattern

[dallen]

got a little more done before the neighbor came over with a little job he needed done.

first up the shop monster said he was on strike till the eats around here improved, I told him to go ahead and strike.


Then we did a little gluing, I may of put on a little too much weight but I wanted to be sure the glue stuck


Started turning the outside, its either the antique MDF or the Southern Yellow Pine not sure which one but one of em was so hard I had to use tap magic for cutting fluid.


Inside turned a lot better, but I think it was because of the CG insert that was in the bar.

Anyway this part is in need of a hub and some gussets now and a lot of wax fillet now, gluing the other half to the MDF as I type.

DA