|
How to Grind a Sheet Metal Drill
|
08-25-2013, 08:30 PM
Something didn't sound right, but it took a few minutes (ok a hour or so) for me to remember. sheet metal bits are sold with 135 point angle, that and 50 cents might get you a cup of coffee (I don't drink it) But I can see that the pilot style drill like you have would work nicely.
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How to Grind a Sheet Metal Drill - by TomG - 08-25-2013, 03:44 PM
RE: How to Grind a Sheet Metal Drill - by EdK - 08-25-2013, 04:31 PM
RE: How to Grind a Sheet Metal Drill - by oldgoaly - 08-25-2013, 06:11 PM
RE: How to Grind a Sheet Metal Drill - by f350ca - 08-25-2013, 07:20 PM
RE: How to Grind a Sheet Metal Drill - by oldgoaly - 08-25-2013, 08:30 PM
RE: How to Grind a Sheet Metal Drill - by TomG - 08-25-2013, 09:25 PM
RE: How to Grind a Sheet Metal Drill - by paulmo101 - 08-26-2013, 09:51 AM
RE: How to Grind a Sheet Metal Drill - by PixMan - 08-26-2013, 01:38 PM
RE: How to Grind a Sheet Metal Drill - by krv3000 - 08-26-2013, 04:07 PM
RE: How to Grind a Sheet Metal Drill - by TomG - 08-26-2013, 04:10 PM
RE: How to Grind a Sheet Metal Drill - by EdK - 08-26-2013, 04:30 PM
RE: How to Grind a Sheet Metal Drill - by f350ca - 08-26-2013, 05:01 PM
|
