08-25-2013, 04:30 PM
the parting line was the edge under the Hex just about all those holes but the holes are all over the part is just that they show up pretty bad in two places, the end that I have ahold of I faced it off and have holes showing up in it. and it was in the bottom of the mold.
I'm thinking that I may repour it tomorrow morning will have to see what the weather brings. anyway I'm going to modify the pattern so I can put a core in it so I don't have to drill thru 2.5 inches of Cast Iron.
DA
I'm thinking that I may repour it tomorrow morning will have to see what the weather brings. anyway I'm going to modify the pattern so I can put a core in it so I don't have to drill thru 2.5 inches of Cast Iron.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!