MetalworkingFun Forum › Machining › General Metalworking Discussion v
here is a project and a half

Thread Modes
here is a project and a half
toolsinbox Offline
Sophmore
***
Posts: 57
Threads: 6
Joined: Aug 2013
Location: Canada
#15
08-25-2013, 03:41 PM
keith's is a Sibley and I think this is a Candy Otto. I am not sure but when I go there again I will look closer
toolsinbox, proud to be a member of MetalworkingFun Forum since Aug 2013.
Reply
Thanks given by:


Messages In This Thread
here is a project and a half - by toolsinbox - 08-18-2013, 04:52 PM
RE: here is a project and a half - by toolsinbox - 08-18-2013, 04:54 PM
RE: here is a project and a half - by toolsinbox - 08-18-2013, 04:56 PM
RE: here is a project and a half - by toolsinbox - 08-18-2013, 04:57 PM
RE: here is a project and a half - by stevec - 08-18-2013, 05:50 PM
RE: here is a project and a half - by EdK - 08-18-2013, 05:54 PM
RE: here is a project and a half - by oldgoaly - 08-18-2013, 07:43 PM
RE: here is a project and a half - by sasquatch - 08-18-2013, 08:46 PM
RE: here is a project and a half - by toolsinbox - 08-18-2013, 09:57 PM
RE: here is a project and a half - by Mayhem - 08-19-2013, 07:36 AM
RE: here is a project and a half - by toolsinbox - 08-20-2013, 12:28 AM
RE: here is a project and a half - by RC1254 - 08-24-2013, 07:05 PM
RE: here is a project and a half - by toolsinbox - 08-25-2013, 03:41 PM
RE: here is a project and a half - by Rickabilly - 08-30-2013, 09:41 PM
RE: here is a project and a half - by oldgoaly - 08-31-2013, 08:55 PM
RE: here is a project and a half - by toolsinbox - 09-03-2013, 04:54 PM



Users browsing this thread: 2 Guest(s)