Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread

Hello There, Guest! Register

Thread Modes

Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread

EdK

Offline

Whipping Boy

Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota

#6

08-21-2013, 09:36 AM

(08-21-2013, 09:34 AM)TomG Wrote: ...That was a piece of sissy steel (12L14) ...
Tom

Rotfl

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by TomG - 08-20-2013, 07:57 PM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by Mayhem - 08-21-2013, 08:09 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by TomG - 08-21-2013, 09:32 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by Highpower - 08-21-2013, 09:58 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by EdK - 08-21-2013, 09:05 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by TomG - 08-21-2013, 09:34 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by EdK - 08-21-2013, 09:36 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by DaveH - 08-22-2013, 04:10 PM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by doubleboost - 08-22-2013, 04:14 PM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by TomG - 08-22-2013, 04:29 PM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by f350ca - 08-22-2013, 05:20 PM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by TomG - 08-22-2013, 06:43 PM

Users browsing this thread: 5 Guest(s)