Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread

Hello There, Guest! Register

Thread Modes

Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread

Mayhem Offline

Offline

purveyor of mischief

Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia

#2

08-21-2013, 08:09 AM

Thanks Tom - that sure is a very nice lathe. Mine doesn't have a QCGB but I can cut down to 1tpi on mine Big Grin

Big Grin

Hunting American dentists since 2015.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by TomG - 08-20-2013, 07:57 PM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by Mayhem - 08-21-2013, 08:09 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by TomG - 08-21-2013, 09:32 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by Highpower - 08-21-2013, 09:58 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by EdK - 08-21-2013, 09:05 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by TomG - 08-21-2013, 09:34 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by EdK - 08-21-2013, 09:36 AM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by DaveH - 08-22-2013, 04:10 PM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by doubleboost - 08-22-2013, 04:14 PM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by TomG - 08-22-2013, 04:29 PM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by f350ca - 08-22-2013, 05:20 PM

RE: Thread Cutting on the Lathe, Part Four - Setting Up the Lathe and Cutting the Thread - by TomG - 08-22-2013, 06:43 PM

Users browsing this thread: 2 Guest(s)