08-20-2013, 10:40 AM
Hey Rick - good to see you back here!
I ended up sliding the table onto a mobile table I had made previously. I just wound the knee to the right hight and pushed
I have filled the void with bog but I have yet to get around to painting it and putting it back together. I contacted Kondia and they were very helpful once I was able to tell them the part numbers I was interested in (it took a while to find the full size image I now have). However, I've had a lot of trouble actually placing an order for the parts. I got this email last week from them:
Dear Darren,
I am very sorry for all of the inconveniences I may have caused you.
I have been involved in too many matters by myself that no time to check and reply to all your emails.
I am in fact on holidays, but when returning you are going to be one of the main matters I will focus my attention on.
I am very sorry although I thought someone else might have replied you.
You will hear from me, I promise you.
I have rebuilt the spindle motor and started putting the top end back together. I'll put together an update soon.
I ended up sliding the table onto a mobile table I had made previously. I just wound the knee to the right hight and pushed
I have filled the void with bog but I have yet to get around to painting it and putting it back together. I contacted Kondia and they were very helpful once I was able to tell them the part numbers I was interested in (it took a while to find the full size image I now have). However, I've had a lot of trouble actually placing an order for the parts. I got this email last week from them:
Dear Darren,
I am very sorry for all of the inconveniences I may have caused you.
I have been involved in too many matters by myself that no time to check and reply to all your emails.
I am in fact on holidays, but when returning you are going to be one of the main matters I will focus my attention on.
I am very sorry although I thought someone else might have replied you.
You will hear from me, I promise you.
I have rebuilt the spindle motor and started putting the top end back together. I'll put together an update soon.
Hunting American dentists since 2015.