MetalworkingFun Forum › Machining › Welding & Casting v
how I make sand core's

Thread Modes
how I make sand core's
doubleboost Offline
Super Moderator
******
Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England
The following 1 user Likes doubleboost's post:
oldgoaly (08-19-2013)
#2
08-19-2013, 04:05 PM
Thanks for that
I have had very limited success with sodium cores
They have been to hard (not collapsing) when the job is poured
I may have been using to much sodium silicate
John
http://www.youtube.com/user/doubleboost
Reply
Thanks given by:


Messages In This Thread
how I make sand core's - by dallen - 08-18-2013, 07:23 PM
RE: how I make sand core's - by doubleboost - 08-19-2013, 04:05 PM
RE: how I make sand core's - by oldgoaly - 08-19-2013, 05:10 PM
RE: how I make sand core's - by dallen - 08-19-2013, 07:31 PM
RE: how I make sand core's - by Mayhem - 08-20-2013, 09:09 AM
RE: how I make sand core's - by dallen - 08-20-2013, 10:53 AM
RE: how I make sand core's - by dallen - 08-25-2013, 02:47 PM
RE: how I make sand core's - by dallen - 08-25-2013, 07:23 PM
RE: how I make sand core's - by Mayhem - 08-26-2013, 09:38 AM
RE: how I make sand core's - by oldgoaly - 08-26-2013, 11:57 AM
RE: how I make sand core's - by dallen - 08-26-2013, 03:35 PM
RE: how I make sand core's - by oldgoaly - 08-26-2013, 05:00 PM
RE: how I make sand core's - by Rickabilly - 08-30-2013, 03:27 PM
RE: how I make sand core's - by dallen - 08-27-2013, 02:39 PM
RE: how I make sand core's - by oldgoaly - 08-27-2013, 04:25 PM
RE: how I make sand core's - by dallen - 08-29-2013, 08:01 PM
RE: how I make sand core's - by chucketn - 08-30-2013, 07:07 AM
RE: how I make sand core's - by dallen - 08-30-2013, 07:48 AM
RE: how I make sand core's - by oldgoaly - 08-30-2013, 08:10 AM
RE: how I make sand core's - by dallen - 08-30-2013, 06:05 PM
RE: how I make sand core's - by chucketn - 08-30-2013, 09:27 AM
RE: how I make sand core's - by doubleboost - 08-30-2013, 03:37 PM
RE: how I make sand core's - by chucketn - 08-30-2013, 04:02 PM



Users browsing this thread: 2 Guest(s)