MetalworkingFun Forum › Machining › Projects v
DC engine refit

Thread Modes
DC engine refit
ScrapMetal Offline
Junior
****
Posts: 275
Threads: 12
Joined: Mar 2012
Location: Nebraska, USA
#2
08-18-2013, 10:29 PM (This post was last modified: 08-18-2013, 10:29 PM by ScrapMetal.)
Cool little diesel engine and nice job on getting it cleaned up.

I'm not too sure of which size it is though but it may be a bit too big for a spring/recoil type starter and maybe just a "hand flipper".

-Ron
11" South Bend lathe - Wells-Index 860C mill - 16" Queen City Shaper
Reply
Thanks given by:


Messages In This Thread
DC engine refit - by krv3000 - 08-18-2013, 06:38 PM
RE: DC engine refit - by ScrapMetal - 08-18-2013, 10:29 PM
RE: DC engine refit - by Mayhem - 08-19-2013, 07:32 AM
RE: DC engine refit - by TomG - 08-20-2013, 08:47 AM
RE: DC engine refit - by stevec - 08-19-2013, 08:28 AM
RE: DC engine refit - by krv3000 - 08-19-2013, 02:21 PM
RE: DC engine refit - by krv3000 - 08-19-2013, 02:39 PM
RE: DC engine refit - by ScrapMetal - 08-19-2013, 08:58 PM
RE: DC engine refit - by krv3000 - 08-20-2013, 04:47 PM
RE: DC engine refit - by MikeWi - 08-20-2013, 05:20 PM
RE: DC engine refit - by ScrapMetal - 08-22-2013, 01:46 AM
RE: DC engine refit - by krv3000 - 08-20-2013, 05:38 PM
RE: DC engine refit - by TomG - 08-22-2013, 08:28 AM
RE: DC engine refit - by stevec - 08-22-2013, 10:30 AM
RE: DC engine refit - by TomG - 08-22-2013, 10:43 AM
RE: DC engine refit - by stevec - 08-22-2013, 12:32 PM



Users browsing this thread: 1 Guest(s)