New part for the Cinci lead screw support
#28
got the pattern basically made just need to do all the fillets and sanding and paint on it tomorrow an hopefully on monday I can pour it again, I did goof on the part of the pattern that the leadscrew goes thru and got it a little on the thick side but thats ok I put it together so that the extra is on the outside be easy to face it off.

sorry no photos today.

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
RE: New part for the Cinci lead screw support - by dallen - 08-17-2013, 10:04 PM



Users browsing this thread: 6 Guest(s)