08-16-2013, 02:11 PM
I could do that if it was just the sand spots but the damn thing is a quarter inch too long, so time I pay someone to cut and weld it I can make a new pattern a lot cheaper as I already have the board, besides who knows this next pattern may even turn out right.
actually the part is probably right if I had the original ratchet gear on the machine but I don't think the one thats on it is right, because to make the pattern for this part I used the broken original support to measure off of.
this shows the original broken part along with the first patten that I really messed up, so I know that the 5 1/4 inches long that I made the pattern is right.
![[Image: support00001.jpg]](http://i1222.photobucket.com/albums/dd484/Superdave257/support00001.jpg)
will post some video of the pour after I do some cutting and hacking on it.
DA
actually the part is probably right if I had the original ratchet gear on the machine but I don't think the one thats on it is right, because to make the pattern for this part I used the broken original support to measure off of.
this shows the original broken part along with the first patten that I really messed up, so I know that the 5 1/4 inches long that I made the pattern is right.
![[Image: support00001.jpg]](http://s1222.photobucket.com/user/Superdave257/media/support00001.jpg.html)
will post some video of the pour after I do some cutting and hacking on it.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!